Electronic Throttle Control Dodge Caliber Cost

According to Repair Pal, the average cost for a Dodge Caliber electronic throttle control replacement is between $608 and $776. Labor costs are estimated between $158 and $200 while parts are priced at $450.

If your Dodge Caliber is equipped with an electronic throttle control (ETC) system, you may be wondering about the cost of repairs if something goes wrong. Thankfully, ETC systems are relatively low-maintenance and shouldn’t require any major repairs. However, if something does go wrong, you can expect to pay anywhere from $200 to $600 for parts and labor.

So, while it’s not a cheap fix, it’s still cheaper than many other potential repair costs.

How to Replace Throttle Body Dodge Avenger & Dodge Caliber (Electronic Throttle Control Light Fix)

Dodge Caliber Electronic Throttle Control Problems

The Dodge Caliber is a great car. It’s stylish, efficient, and practical. However, there have been reports of electronic throttle control problems with the Caliber.

This can be a serious problem because it can cause the car to lose power and stall unexpectedly. If you own a Dodge Caliber, it’s important to be aware of this issue and to have your car checked by a qualified mechanic if you suspect there may be a problem. In some cases, the electronic throttle control system may need to be completely replaced.

Luckily, Dodge offers an extended warranty on this particular component, so if your car is still covered, you shouldn’t have to pay anything out of pocket to get it fixed. If you’re having trouble with your Caliber’s electronic throttle control system, don’t hesitate to take it to a qualified mechanic for diagnosis and repair. It’s important to keep your car in top running condition so that you can enjoy all that it has to offer!

Dodge Caliber Throttle Body Replacement

The throttle body on your Dodge Caliber is an important part of the engine’s air intake system. It regulates the amount of air that flows into the engine, and if it becomes damaged or clogged, it can cause a variety of problems. If you’re experiencing issues with your Caliber’s throttle body, it may be time to replace it.

Throttle body replacement is a fairly simple process, but it’s one that should be done by a qualified mechanic. The first step is to remove the old throttle body from the engine bay. This will require disconnecting a few sensors and electrical connections.

Once the old throttle body is out, you can install the new one in its place. Be sure to reconnect all sensors and electrical connections before starting the engine. If you’re experiencing any issues with your Dodge Caliber’s throttle body, don’t hesitate to have it replaced.

A new throttle body can restore normal engine operation and improve performance.

2007 Dodge Caliber Throttle Body Replacement

Your 2007 Dodge Caliber is equipped with a throttle body that helps to regulate the airflow into the engine. Over time, this part can become clogged or damaged, affecting the performance of your vehicle. If you notice any issues with your throttle body, it’s important to have it replaced as soon as possible.

Here at Joe’s Auto Service, we can take care of all your throttle body replacement needs. We’ll start by inspecting the throttle body and other related parts to make sure that it is indeed the culprit for yourSymptoms can include decreased fuel efficiency, loss of power while accelerating, and strange idling behavior. Once we confirm that the throttle body needs to be replaced, we’ll get right to work.

The entire process usually takes about an hour or two from start to finish. We only use OEM or certified aftermarket parts for all our repairs, so you can rest assured knowing that your 2007 Dodge Caliber is in good hands. Give us a call today to schedule an appointment forthrottle body replacement service!

2007 Dodge Caliber Throttle Body Relearn Procedure

If your 2007 Dodge Caliber is having issues with the throttle body, you may need to do a throttle body relearn procedure. This can be done easily at home with no special tools needed. Here’s a step-by-step guide on how to do it:

1) Make sure your car is in Park and the engine is off. 2) Press and hold the gas pedal all the way down for 5 seconds. 3) Turn the ignition key to the ON position (do not start the engine).

4) Release the gas pedal and press it again for 15 seconds. 5) Start the engine and drive normally. That’s all there is to it!

If you find that your Caliber is still having issues with the throttle body after doing this relearn procedure, then you may need to take it into a mechanic for further diagnosis.

Dodge Caliber Throttle Body Reset

The Dodge Caliber is a compact car that was first introduced in 2007. It replaced the Dodge Neon and was produced until 2012. The Caliber was available in both front-wheel and all-wheel drive configurations.

It had a transverse front-engine layout and used a continuously variable transmission (CVT). One issue that some owners of the Dodge Caliber have reported is an issue with the throttle body. The throttle body is responsible for controlling the amount of air that flows into the engine.

If there is an issue with the throttle body, it can cause problems with the engine idling or stalling. There are a few things that you can do to reset the throttle body on your Dodge Caliber. One method is to disconnect the battery for 30 seconds and then reconnect it.

This will reset all of the electronic systems in your car, including the throttle body. Another method is to remove the positive terminal from your battery, wait 10 seconds, and then reconnect it again. Doing this will also reset your car’s electronic systems, including the throttle body control unit (TCU).

If you are having issues with your Dodge Caliber’s throttle body, there are a few things that you can do to reset it yourself before taking it into a mechanic or dealership. Try one of these methods and see if they help resolve any issues that you may be having with your car’s throttle body!

2007 Dodge Caliber Throttle Body Recall

In 2007, Dodge issued a recall for certain models of their Caliber vehicles due to a problem with the throttle body. The recall affected approximately 20,000 vehicles that were equipped with a 2.0L engine and manual transmission. Dodge discovered that the throttle body assembly on these vehicles could fail, resulting in the engine stalling or shutting off completely.

This posed a serious safety risk, as it could happen while the vehicle was being driven. As such, Dodge issued a recall and offered to repair the affected vehicles free of charge. If you own a 2007 Dodge Caliber with a 2.0L engine and manual transmission, be sure to check if your vehicle is affected by this recall.

If it is, contact your local dealer to schedule a service appointment to have the throttle body repaired.

Electronic Throttle Control Dodge Caliber Cost

Credit: www.amazon.com

How Much Does It Cost to Fix Electronic Throttle Control?

Assuming you are referring to a throttle body and not an electronic control module, the cost to replace a throttle body can range anywhere from $200 to $600. The majority of the cost is for labor, as the actual part is only a few hundred dollars. The price will vary depending on the make and model of your car as well as the location of the repair shop.

How Much Does It Cost to Replace an Electronic Throttle?

How much does it cost to replace an electronic throttle? This is a difficult question to answer without knowing the make and model of the vehicle, as well as the specific throttle in question. However, we can provide some general guidance.

Generally speaking, it will cost between $200 and $1000 to replace an electronic throttle, with the vast majority of replacements falling somewhere in the middle of that range. The most important factor in determining the cost of replacement will be the labor involved; if the replacement can be done relatively easily by a qualified mechanic, it will likely fall on the lower end of that price range. If significant disassembly is required, or if special tools are needed, then the cost will be closer to $1000.

As always, we recommend consulting with a qualified professional for a more accurate estimate specific to your situation.

How Much Does It Cost to Replace a Throttle Body on a 2007 Dodge Caliber?

If you’re the do-it-yourself type, you can expect to pay anywhere from $75 to $150 for a new throttle body Assembly. The cost of the part will vary depending on your location and whether you get it from a dealership or aftermarket supplier. If you have someone else do the work for you, labor costs will be anywhere from $150 to $200.

So all told, budget between $225 and $350 for this repair.

How Much is a Throttle Body for a 2012 Dodge Caliber?

If your 2012 Dodge Caliber is experiencing throttle body issues, you may be wondering how much it will cost to replace the part. The good news is that a new throttle body for a 2012 Dodge Caliber can be found for around $200. However, depending on the severity of the issue, you may also need to have your ECU (Engine Control Unit) reprogrammed, which could add an additional cost of around $100.


The electronic throttle control on a Dodge Caliber can be a costly repair. However, it is important to have this system checked and repaired as soon as possible if there are any issues. By doing so, you can avoid larger and more expensive problems down the road.

Leave a Comment